Tungsten carbide glass cutter is welcomed for cutting plate glass. And it is the tungsten carbide cutting wheel that plays a role of scoring a line on the glass, and then split it through mechanical stress along the line. The advantage of this method is that the processing method is simple, the glass can be effectively broken, and the cost is relatively low.

Tungsten carbide glass cutter for cutting wired glass adopts tungsten carbide as the material of its cutting wheel and non-slip pen design, which has characteristics of sharp cutting, fast speed, high precision, wear resistance, corrosion resistance, high hardness and long service life. Using tungsten carbide glass cutter, it is easy to get smooth, flat and beautiful cut surface. Also, it is non-slip and is safer to use.

Tungsten carbide glass cutter is a tool with a small tungsten carbide cutting wheel, which is widely applied for glass cutting as it has advantages of high hardness, wear resistance, heat resistance, corrosion resistance, good strength and toughness. Especially, high hardness and high abrasion resistance of such a glass cutter remains basically unchanged even at a temperature of 500 °C. Also, it still has a high hardness at 1000 °C.

How to improve photocatalytic performance of yellow tungsten oxide? The researchers proposed a method to improve the photocatalytic performance of yellow tungsten oxide (tungsten trioxide/ WO3). Through this method, WO3 photocatalyst showed higher photocatalytic activity than the single crystal phase WO3in the photocatalytic degradation of water to produce hydrogen and degradation of pollutants.

It is reported that yellow tungsten oxide, is not only a typical n-type semiconductor material, but a promising semiconductor photocatalytic material. Yellow tungsten oxide, also known as tungsten trioxide or WO3, is considered to be a semiconductor photocatalytic material with great development potential due to its high solar energy utilization rate, good visible light response and strong photocorrosion resistance, and has been widely used in hydrogen production from photolysis water and catalytic degradation of organic pollutants.

Yellow tungsten oxide can be applied for organic waste gas purification in heavy polluting industries. There are two appropriate measures for treatment of organic waste gas in heavily polluted industries: recovery method - separation and recovery through physical methods; elimination method - reduction of toxic waste gas through chemical and biological reactions. Wherein, using yellow tungsten oxide to treat organic waste gas belongs to the photocatalytic oxidation method in elimination method.

Tungsten alloy collimator provides the perfect solution for radiation shielding and collimation in nuclear medicine. Because tungsten alloy has excellent radiation attenuation properties, such a collimator has a reduced volume than traditional lead collimator, while it can still effectively shield harmful X-ray and gamma radiation.

SPECT tungsten alloy multipinhole collimator is tungsten alloy collimator applied for nuclear medicine tomographic imaging technique using gamma rays. And sometimes SPECT tungsten alloy multipinhole collimator is an integrated SPECT collimator for laboratory rats. Tungsten alloy multi-pinhole collimator is an indispensable four-dimensional accurate quantitative imaging and animal experiment auxiliary system.

Tungsten alloy collimator is a device used to restrict the photon acceptance angle to provide positional information for detected photons. SPECT tungsten alloy collimator is a thick sheet of tungsten alloy of high atomic number, pierced by an array of holes.

Tungsten alloy collimator is an important part of a gamma camera (γ camera). And it plays the role of radiation guidance (collimation) and radiation protection (reducing the patient's exposure to gamma rays) on the core component of the gamma camera.