Tungsten Carbide Glass Cutter

Tungsten carbide glass cutter refers to the material of cutter bit, which is the key part of the glass cutter. Cutter bit has a relatively large angle but very sharp blade, by a glass across the glass surface, the bottom edge will leave a very sharp groove on the glass. The glass surface is then grooved by pulling action, since the bottom is very sharp, there is a big stress concentration, the brittle glass material is easily split along the groove. There are many types of tungsten carbide glass cutter:
1. By the cutter bit material: natural diamond glass cutter, synthetic diamond glass cutter, carbide glass cutter;
2. By the cutter bit material: Aluminum handle glass cutter, red wooden handle glass cutter, plastic handle glass cutter, bronze handle glass cutter;
3. By the function: Multifunctional glass cutter, electroprobe glass cutter, dual-use positioning glass cutter and connected tape glass cutter;
4. By the shape and using: Straight shank, hand-held, T-typed, rotated type and so on.

When using tungsten carbide glass cutter, you should notice that:
1. Cutting 2-3mm plate glass: Use 2mm × 12mm thin wooden ruler, check the cutting size and consider that the gap of 3mm and 2mm incision. Put the size of one side against the glass, grasp the blade end straightly draws back;
2. Cutting 2-3mm plate glass: Except the method above, there is another method that use 4mm × 50mm ruler, the cutter against the ruler. It should be noticed that b brush kerosene on the incision before cutting;
3. Cutting 4-6mm large plate glass: Before cutting, we should put a wad velvet on the working table to ensure the uniform cutting force;
4. Cutting wired glass: Wired glass has rugged cutting surface, it is easy to slip cutting edge, so the force and speed is important in case of bending;
5. Cutting patterned glass: Embossed surface faces down and the method is the same with the wired glass;
6. Cutting frosted glass: It is the same with the cutting method plate glass.

• < Prev
• Next >