The Overhaul of Tungsten Contacts Ablation in Distributor - I

1. The overhaul of tungsten contacts gap in distributor.

Open the lid of the distributor, shake and rotate the engine, so that tungsten contacts of the distributor is in good state, then, check the gap among tungsten contacts, to see whether it is less than 0.37mm, if less than 0.37mm, we need to check the extent of tungsten contacts ablation, otherwise, you do not need to check.

If the extent of tungsten contacts ablation is very serious, then: Firstly, put on gloves, remove the tungsten contacts, and put it on a flat stone; then, get some oil in your hand, then pull back and forth parallel to polish tungsten contacts, to prevent partial wear during, you should not use hand to swing it .

If the extent of tungsten contacts ablation is not serious, then: using platinum sand bar or fine sandpaper to smooth ablation. When using fine sandpaper, fine sandpaper can be turned over, so its sand finish is outwardly facing to polish tungsten contacts, and then be turned back, and erasing the dirt left by milling until tungsten contacts is clean.




Tungsten Metals Manufacturer & Supplier: Chinatungsten Online - http://www.tungsten.com.cn
 Tel.: 86 592 5129696; Fax: 86 592 5129797
 Email: sales@chinatungsten.com
 Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
 Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
 Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn

• < Prev
• Next >