Tungsten Carbide Turning Tool Sharpening
- Details
- Category: Tungsten Information
- Published on Friday, 31 October 2014 18:49
Tungsten carbide turning tool sharpening should be conducted by adopting correct posture and methods, and paying attention to related safety knowledge.
Correct sharpening posture and methods towards tungsten carbide turning tools:
I.Operators shall stand on the side of grinding machines, in case of getting hurts due to grinding wheel burst.
II.Operators shall separate their two hands to a certain distance when holding the tool, and clamp their waist with tow elbows so that shake generated while grinding will be reduced.
III.When conducting major and minor flank grinding, turning tools should be placed at the horizontal center of grinding wheel with tool nose sticking up about 3°~8°. After touching the grinding wheel, the tungsten carbide turning tool should move right and left in a horizontal direction. When the turning tool leaves the grinding wheel, it should rise for a little in case that the cutter edge ground is damaged by the grinding wheel.
IV.When conducting flank face grinding, the back of the toolbar should tilt to the left with a tool cutting edge angle.
V. When conducting minor flank grinding, the back of the toolbar should tilt to the right with an end cutting edge angle.
Safety knowledge during tungsten carbide turning tool grinding:
I.Before grinding, operators shall check if there is any crack on the grinding wheel and whether the grinding wheel spindle nut has been tightened. And the grinding wheel should be tried first before being put into use in case that it bursts and hurts operators.
II.Operators shall wear protective glasses during grinding in case that gravel and scrap iron would run into their eyes.
III.Operators shall not stand right in front of the rotating direction of the grinding wheel in case of accidents.
IV.When conducting small tool bit grinding, the tool bit shall be placed into the toolbar so that operators can hold it tightly.
Tungsten Manufacturer & Supplier: Chinatungsten Online - http://www.chinatungsten.com
Tel.: 86 592 5129696; Fax: 86 592 5129797
Email: sales@chinatungsten.com
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn
sales@chinatungsten.com
闽公网安备 35020602000140号