Tungsten carbide boring cutter, a kind of boring tool with a round handle, can be applied in inner bore processing, chambering, and so on, and is specially used in rough, semi-finish and finish processing towards existing bores. 

 

Installation steps of tungsten carbide boring cutters:

I. Tied the sheath to the shank by bolt.

II. Install the fine boring cutter base on the sheath.

III. Install the clump weight on the sliding block.

IV. Cutting tools adjustments:

(1) Loosen the bolt.

(2) Make rough adjustments towards the tool apron.

(3) Tighten the bolt.

V. Adjust the clump weight in the same way and adjust the dynamic balance.

VI. Tighten the bolt, try boring, measure the size of the processed bore and compare it to the required size, and then figure out the deviation value of number.

VII. Loosen the bolt and screw the dial. 

VIII. Tighten the bolt and rework the workpiece to the required size.

 

Precautions during tungsten carbide boring cutter installation:

Do not overexert the adjustment towards fine boring cutter bits; do not touch places sealed up by red lacquer; do maintenance regularly and add lubricating oil. 

 

 

 

Tungsten Manufacturer & Supplier: Chinatungsten Online - http://www.chinatungsten.com
Tel.: 86 592 5129696; Fax: 86 592 5129797
Email: sales@chinatungsten.com
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn