Tungsten Alloy Rivet Bucking Bar Orientation 2

3. Push rivet back into place with gun set and reposition rivet bar, if necessary, to maintain its point of balance on the rivet. (repeat steps 2 and 3 until point of balance is determined). Often the index finger can be placed on the back of the rivet bar directly opposite the rivet tail. It then becomes the 'sensor' for correct bar position.



4. Pressure is held on gun while riveting. Tungsten alloy rivet bucking bar is held with only moderate force (otherwise rivet may be set with head proud of surface). A rubber grommet may be used over the rivet tail to assist in squeezing parts together during riveting. It acts as a 'pressure plate'.




Tungsten Alloy Manufacturer & Supplier: Chinatungsten Online - http://www.buckingbar.com.cn
Tel.: 86 592 5129696; Fax: 86 592 5129797
Email:  sales@chinatungsten.com
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn

• < Prev
• Next >