Getting Tungsten Disulfide to Stick

Tungsten disulfide is commonly known by its chemical formula, WS2. Tungsten disulfide can be used as a dry lubricant for mechanical parts, and is often preferred because it can be used within a wide range of temperatures and will not introduce contaminants into the machinery. Sandblasting equipment can be used to apply the lubricant. Otherwise, WS2 can be applied with a buffing wheel. If the WS2 can be mixed with wet lubricants in your application, it may be added to oil or other lubricants. If you are applying WS2 to small parts, a tumbler may be used.

Instructions

Buffing
1
Clean the part with a rag to get all of the grease off.

2
Mix the tungsten disulfide powder with rubbing alcohol in a small glass jar. Start by pouring in just a small amount of alcohol and mixing thoroughly with a spoon. Keep pouring more alcohol until you have a grey paste.

3
Spread the paste onto the part and the buffing wheel. Allow them some time to dry thoroughly.

4
Turn on the wheel and press the part up against it, turning the part and buffing it until the part is coated a grey color.

Tumbling
5
Clean the part with a rag to get all of the grease off.

6
Put several of your small parts or bullets into the empty aspirin bottle.

7
Fill the bottle three-quarters of the way up with tungsten disulfide.

8
Place the bottle in the tumbler. Turn the tumbler on for approximately five hours.

Add Tungsten Disulfide to Lubrication
9
Clean the part with a rag to get all of the grease off.

10
Mix some tungsten disulfide in with fresh lubrication, oil or grease.

11
Grease the part, change the oil oar and apply the new lubrication. The tungsten disulfide will slowly coat the parts as the lubrication moves through the machinery.

Sand Blasting
12
Clean the part with a rag to get all of the grease off.

13
Blast the part with a light layer of aluminum oxide.

14
Clean the part off with a clean soft cloth so there is no trace of aluminum oxide powder.

15
Set the sand blaster to 120 PSI and to cold pneumatic air. Blast the tungsten disulfide onto the part until the part becomes a silver-grey color.

16
Clean the excess tungsten disulfide dust off with another clean cloth. Do not rub too hard or you will remove the powder.

Tungsten Manufacturer & Supplier: Chinatungsten Online - http://www.chinatungsten.com
Tel.: 86 592 5129696; Fax: 86 592 5129797
Email: sales@chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Tungsten News & Tungsten Prices, WML Version: http://m.chinatungsten.com

• < Prev
• Next >