The Main Reasons of Tungsten Contacts Gap Misalignment of Distributor

When the car is working, result in that the main reasons of tungsten contacts gap misalignment of distributor are shown as below:

1. Tungsten contacts ablation, it will cause the increase of tungsten contacts gap after the surface oxide shedding.
2. The top block of movable arm of contact wears, so the gap of tungsten contacts becomes smaller.
3. The distributor between the shaft and bushing will wear on each other, not only result in the distributor shaft swing phenomenon occurs, but will make the tungsten contact gap volatile, suddenly become small or big.

4. Driver’s improper adjustment. Under normal circumstances, the driver would use visual methods and their experience to adjust the gap of tungsten contacts, rather than through plug inspections and adjustments. This can cause the size misalignment of the tungsten contact gap.

Therefore, in order to improve the engine's power to reduce the consumption amount of fuel and maintain the normal operation of the engine, you should correctly adjust the gap of tungsten contact of distributor.



 

Tungsten Metals Manufacturer & Supplier: Chinatungsten Online - http://www.tungsten.com.cn
 Tel.: 86 592 5129696; Fax: 86 592 5129797
 Email: sales@chinatungsten.com
 Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
 Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
 Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn

• < Prev
• Next >