Main Factors on the Quality of Tungsten Points (4)

3. The parameter of rotary swaging mold could lowering the quality of tungsten points

When design the rotary swaging mold, the bearing length and ovality is not appropriately chose.
The control is inappropriate when repairing the mold, therefore, the two-part having inconsistent parameter, and they have bad finish, different size, and the arc between deformation zone and convergence aren’t in the same plane;

When repairing worn hammer, because the height of hammers vary one another among them and the highest point of the hammers don’t focus on the center line. So, when swaging, there will be deformation cause by uneven stress.


 

Tungsten Metals Manufacturer & Supplier: Chinatungsten Online - http://www.tungsten.com.cn
 Tel.: 86 592 5129696; Fax: 86 592 5129797
 Email: sales@chinatungsten.com
 Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
 Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
 Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn

• < Prev
• Next >