From "Metal Injection Molding Process Research Experiments of Tungsten Electrodes - Degreasing And Sintering" to N-Heptane MSDS - Ⅵ
- Details
- Category: Tungsten Information
- Published on Wednesday, 02 September 2015 17:42
N-heptane, acting a kind of liquid material in degreasing solvent process in "Metal Injection Molding Process Research Experiments of Tungsten Electrodes - Degreasing And Sintering", and the following article will introduce the MSDS (Material Safety Data Sheet)Part 9: Physical And Chemical Properties and Part 10: Stability And Reactivity relevant content, specific see below:
Part 9: Physical and Chemical Properties
The main ingredients: pure
Appearance: colorless, volatile liquid
PH: No data
Melting point: -90.5 ℃
Boiling point: 98.5 ℃
Flash Point: -4 ℃
Ignition temperature: 204 ℃
Critical temperature: 201.7 ℃
Relative density: 0.68 (water = 1)
Relative vapor density: 3.45 (Air = 1)
Vapor pressure: 5.33 kPa (22.3 ℃)
Heat of combustion: 4806.6 kJ / mol
Critical pressure: 1.62 MPa
Logarithm of the octanol / water partition coefficient: No data
Lower explosion limit: 1.1% (V / V)
Upper explosion limit: 6.7% (V / V)
Solubility: insoluble in water, soluble in alcohol, soluble in ether and chloroform.
Main application: as octane measurement standards, solvents, as well as for organic synthesis, for the preparation of laboratory reagents.
Other Properties:
Part 10: Stability And Reactivity
Stability:
Avoid: Strong oxidizing agents
Conditions to avoid: No data
Hazardous Polymerization: No data
Decomposition products: No data
Tungsten Metals Manufacturer & Supplier: Chinatungsten Online - http://www.tungsten.com.cn
Tel.: 86 592 5129696; Fax: 86 592 5129797
Email: sales@chinatungsten.com
Tungsten & Molybdenum Information Bank: http://i.chinatungsten.com
Tungsten News & Tungsten Prices, 3G Version: http://3g.chinatungsten.com
Molybdenum News & Molybdenum Price: http://news.molybdenum.com.cn